Hyundai Accent: Heated Oxygen Sensor (HO2S). Description and Operation

Heated Oxygen Sensor (HO2S) consists of zirconium and alumina and is installed both upstream and downstream of the Manifold Catalytic Converter. The sensor output voltage varies in accordance with the air/fuel ratio.

The sensor must be hot in order to operate normally. To keep it hot, the sensor has a heater which is controlled by the ECM via a duty cycle signal. When the exhaust gas temperature is lower than the specified value, the heater warms the sensor tip.

Installation

• Install the component with the specified torques. • ...

Heated Oxygen Sensor (HO2S). Specifications

Specification HO2S [Bank 1/Sensor 1] Item Specification Heater Resistance (Ω) 2.4 ~ 4.0 [20°C(68°F)] HO2S [Bank 1/Sensor 2 ...

See also:

Replacement
Repair tire after using the Tire Mobility Kit (TMK) When the TPMS warning lamp OFF 1. Remove the TMK repaired tire, wheel and TPMS sensor. (Refer ...

Removal
1. Remove the ignition key from the vehicle. 2. Disconnect the battery negative cable and wait for at least three minutes before beginning ...

Injector. Schematic Diagrams
Circuit Diagram (M/T) (A/T) ...