Hyundai Accent: Inspection
| 1. |
Turn ignition switch OFF.
|
| 2. |
Disconnect the oil temperature sensor connector.
|
| 3. |
Measure resistance between sensor signal terminal and sensor ground
terminal.
|
| 4. |
Check that the resistance is within the specification.
|
Removal
Replacing an on/off solenoid valve (SS-A, SS-B) does not require
additional hydraulic pressure adjustment; however, the hydraul ...
See also:
Installation
1.
Installation is reverse of removal.
Fuel pump plate
cover installation bolt :
1.96 ~ 2.94 N.m (0.2 ~ 0.3 kgf.m, 1.44 ~
2 ...
Inspection
Driver Airbag (DAB)
If any improper parts are found during the following inspection, replace
the airbag module with a new one.
...
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the crash pad lower panel.
(Refer to the BD group - "Crash pad")
...
Hyundai Accent Manuals
В© 2011-2026 Copyright www.hamanual.com