Hyundai Accent: Removal
| 1. |
Turn the ignition switch OFF and disconnect the battery
negative (-) cable.
|
| 2. |
Remove the resonator and the air intake hose (Refer
to “Intake And Exhaust System” in EM group).
|
| 3. |
Disconnect the ETC module connector (A).
|
| 4. |
Disconnect the coolant hoses (A).
|
| 5. |
Remove the installation bolts, and then remove the
ETC module (A) from the engine.
|
Inspection
Throttle Position Sensor (TPS)
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Start the engine and measure the output voltage of
...
Installation
•
Install the component with the specified
torques.
•
...
See also:
Removal
•
Do not spill brake fluid on the vehicle;
it may damage the paint if brake fluid does contac ...
Repair procedures
Component Replacement After Deployment
Before doing any SRS repairs, use the GDS to check for DTCs. Refer
to the Diagnostic Tr ...
ECM Terminal And Input/Output signal [M/T]
ECM Terminal Function (M/T)
Connector [EGGM-AG]
Pin No.
Description
Connected to
...
Hyundai Accent Manuals
© 2011-2026 Copyright www.hamanual.com