Hyundai Accent: Installation

Removal

1. Turn the ignition switch OFF and disconnect the negative (-) battery cable. 2. Disconnect the accelerator position sensor connector ...

Delivery Pipe. Repair procedures

...

See also:

Installation
1. Installation is reverse of removal. Fuel pump plate cover installation bolt : 1.96 ~ 2.94 N.m (0.2 ~ 0.3 kgf.m, 1.44 ~ 2 ...

Inspection
1. Turn the ignition switch OFF. 2. Disconnect the OCV connector. 3. Measure resistance between the OCV termina ...

Rear combination light bulb replacement (4 Door)
(1) Stop and tail light (2) Rear turn signal light (3) Back-up light (4) Side marker 1. Open the trunk lid. 2. Remove the service cover by pulling out the service cover. 3. Remove the sock ...