Hyundai Accent: Removal| 1. |
Turn the ignition switch OFF and disconnect the negative
(-) battery cable.
|
| 2. |
Disconnect the accelerator position sensor connector
(A).
|
| 3. |
Remove the installation nuts (B), and then remove
the accelerator pedal module.
|
InstallationDriving in flooded areas
Avoid driving through flooded areas unless you are sure the water is no higher
than the bottom of the wheel hub. Drive through any water slowly. Allow adequate
stopping distance because brake perf ...
Installation
•
Install the component with the specified
torques.
•
...