Items |
Specified lubricants |
Quantity |
Input shaft spline |
CASMOLY L9508 |
0.2g |
clutch release cylinder assembly |
Brake fluid DOT 3 or DOT |
As required |
Clutch pedal shaft and bushings |
Chassis grease SAE J310a, NLGI No.1 |
Valve Body. Components and Components Location
Components Location
1. PCV adjust screw
2. Solenoid valve
3. Oil temperature sensor
4. Accumulator
5. Low & reverse brake(LR/B) pressure flow hole
6. Und ...
Driving in flooded areas
Avoid driving through flooded areas unless you are sure the water is no higher
than the bottom of the wheel hub. Drive through any water slowly. Allow adequate
stopping distance because brake perf ...
Removal
When replacing the ECM, the vehicle equipped with
the immobilizer must be performed procedure as below.
[In the ...