Inspection
1. |
Remove the front door trim panel.
(Refer to the BD group - "Front door")
|
2. |
Disconnect the connector from the motor.
|
3. |
Connect the motor terminals No.4 directly to battery voltage (12V)
and connect the motor terminals No.3 and No.6 directly to battery (-).
And then check that the motor operates smoothly. If the operation is
abnormal, replace the motor.
[Safety Power Window]
|
4. |
Connect the motor terminals directly to battery voltage (12V)
and check that the motor operates smoothly. Next, reverse the polarity
and check that the motor operates smoothly in the reverse direction.
If the operation is abnormal, replace the motor.
[General]
|
1. |
Remove the rear door trim panel.
(Refer to the BD group - "Rear door")
|
2. |
Disconnect the 2P connector from the motor.
|
3. |
Connect the motor terminals directly to battery voltage (12V)
and check that the motor operates smoothly. Next, reverse the polarity
and check that the motor operates smoothly in the reverse direction.
If the operation is abnormal, replace the motor.
|
Tightening Torque Table Of Standard Parts
Bolt nominal
diameter (mm)
Pitch (mm)
Torque Nm (kg.cm, lb.ft)
Head Mark 4
Head Mark 7
...
Pre-tensioner seat belt
Your vehicle is equipped with driver's and front passenger's pre-tensioner seat
belts. The purpose of the pre-tensioner is to make sure that the seat belts fit
tightly against the occupa ...
Shift Lever. Components
and Components Location
Components
1. Shift lever knob & boot assembly
2. Shift lever assembly
3. Shift cable assembly
4. Select cable assembly
5. Retainer
...