Hyundai Accent: Installation

Hyundai Accent RB (2010-2018) Service Manual / Restraint (Advanced) / Seat Belt Pretensioner / Seat Belt Pretensioner (BPT). Repair procedures / Installation

1.	Remove the ignition key from the vehicle.

2.	Disconnect the battery negative cable and wait for at least three minutes.

Install the seat belt pretensioner with mounting bolts (B, C).

Tightening torque [Bolt B]:

39.2 ~ 54.0 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft)

4.	Connect the seat belt pretensioner (BPT) connector (A).

Install the upper anchor bolts.

Tightening torque:

39.2 ~ 54.0 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft)

Install the following parts.

(Refer to the Body group - "Interior trim")

A.	Center pillar trim

B.	Door scuff trim

Insert the seat belt to the anchor pretensioner (A).

Make sure the lock pin is connected in properly.

8.	Reconnect the battery negative cable.

After installing the seat belt pretensioner, confirm proper system operation:

A.	Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.

Removal

1. Disconnect the battery negative cable, and wait for at least three minutes before beginning work. 2. Remove the seat belt after pushing ...

Anchor Pretensioner (APT). Description and Operation

Description Front anchor pretensioner operates as well as Belt Pretensioner at the same time If it gets into its deploy condition after a collision. It is located at near anchor on driver se ...

Hyundai Accent: Installation

Removal

Anchor Pretensioner (APT). Description and Operation

See also:

Hyundai Accent Manuals