Hyundai Accent Manuals

Hyundai Accent: Removal - Brake Line. Repair procedures - Brake System - Brake SystemHyundai Accent: Removal

Hyundai Accent RB (2010-2018) Service Manual / Brake System / Brake System / Brake Line. Repair procedures / Removal

1.
Disconnect the brake fluid level switch connector, and remove the reservoir cap.
2.
Remove the brake fluid from the master cylinder reservoir with a syringe.
Do not spill brake fluid on the vehicle, it may damage the paint; if brake fluid does contact the paint, wash it off immediately with water.
3.
Remove the wheel & tire.
4.
Loosening the tube flare nut (B).
Tightening torque:
12.7 ~ 16.7 N.m (1.3 ~ 1.7 kgf.m, 9.4 ~ 12.3 lb-ft)
[Front]

[Rear]
5.
Disconnect the brake tube by remove the brake hose clip (A).
6.
Disconnect the brake hose from the brake caliper by loosening the bolt (A).
Tightening torque:
24.5 ~ 29.4 N.m (2.5 ~ 3.0 kgf.m, 18.1 ~ 21.7 lb-ft)
[Front disc brake]

[Rear Disc brake]

Brake Line. Repair procedures
...

Inspection
1. Check the brake tubes for cracks, crimps and corrosion. 2. Check the brake hoses for cracks, damage and fluid leakage. 3 ...

See also:

Components(2)
[Sedan] 1. Roof trim 2. Retainer 3. Sunvisor 4. Assist handle ...

Closing the hood
1. Before closing the hood, check the following: All filler caps in engine compartment must be correctly installed. Gloves, rags or any other combustible material must be removed from the eng ...

Adjustment
Adjusting the control cable 1. Set room side AT lever(shift lever) and automatic transaxle side manual control lever to "N" position. 2. ...

Hyundai Accent Manuals

В© 2011-2026 Copyright www.hamanual.com