Hyundai Accent: Removal
| 1. |
Turn ignition switch OFF.
|
| 2. |
Remove the crash pad lower panel.
(Refer to the Body group - "Crash pad")
|
| 3. |
Disconnect the stop lamp switch connector (A).
|
| 4. |
Remove the shift lock cable (B) after removing the snap pin and
the clip.
|
| 5. |
Remove the BCM.
(Refer to the Body Electrical group - "BCM".)
|
| 6. |
Remove the mounting bracket bolts (B).
|
| 7. |
Remove the snap pin (A) and clevis pin (B).
|
| 8. |
Remove the brake pedal member assembly mounting nuts (A) and then
remove the brake pedal assembly.
|
Inspection
1.
Check the bushing for wear.
2.
Check the brake pedal for bending or twisting.
3.
Check the brake pedal retur ...
See also:
Replacement
The injector combustion seal should be replaced new one to
prevent leakage after removing the injector.
1.
Remove the combustion seal (A) with a wire cutter.
...
Front Wiper Motor. Components
and Components Location
Component Location
1. Cap
2. Nut
3. Wiper arm & blade
4. Rivet
5. Cowl top cover
6. Bolt
7. Wiper motor & linkage assembly
...
Side Impact Sensor (SIS). Description and Operation
Description
The Side Impact Sensor (SIS) system consists of two front SIS which are
installed inside the Center Pillar (LH and RH). They are remote sensors that
detect acceleration due to co ...
Hyundai Accent Manuals
В© 2011-2026 Copyright www.hamanual.com