Hyundai Accent: Installation

Removal

1. Disconnect the negative (-) battery terminal. 2. Remove the trunk trim. (Refer to the BD group - " Trunk Lid") ...

Hazard Lamp Switch. Repair procedures

...

See also:

Installation
• Do not turn the ignition switch ON and do not contact the battery cable while replacing the ...

Inspection
1. Measure the output voltage between the terminal of the wheel speed sensor and the body ground. ...

Checking the engine oil level
1. Be sure the vehicle is on level ground. 2. Start the engine and allow it to reach normal operating temperature. 3. Turn the engine off and wait for a few minutes (about 5 minutes) for the oil ...