Hyundai Accent: Removal
Replacing an on/off solenoid valve (SS-A, SS-B) does not require
additional hydraulic pressure adjustment; however, the hydraulic pressure
will need to be adjusted after replacing the VFS solenoid valve. If
replacing the VFS solenoid valve; also replace the valve body assembly.
(Refer to "Valve Body" in this group)
|
Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the oil temperature sensor connector.
3.
Measure resistance between ...
Line Pressure Control Solenoid Valve. Description and Operation
Description
line pressure control solenoid valve is attached to the valve body. This
variable force solenoid valve directly controls the hydraulic pressure inside
the line pressure.
...
See also:
Installation
•
Install the component with the specified
torques.
•
...
Resetting the sunroof
Whenever the vehicle battery is disconnected or discharged, or related fuse is
blown, you must reset your sunroof system as follows:
1. Turn the ignition switch to the ON position and close the sun ...
Rear Torsion Beam Axle. Repair
procedures
Replacement
[Disc Type]
1.
Remove the rear wheel & tire.
Tightening torque :
88.3 ~ 107.9N.m(9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft) ...
Hyundai Accent Manuals
© 2011-2026 Copyright www.hamanual.com