Hyundai Accent: Removal
Replacing an on/off solenoid valve (SS-A, SS-B) does not require
additional hydraulic pressure adjustment; however, the hydraulic pressure
will need to be adjusted after replacing the VFS solenoid valve. If
replacing the VFS solenoid valve; also replace the valve body assembly.
(Refer to "Valve Body" in this group)
|
Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the oil temperature sensor connector.
3.
Measure resistance between ...
Underdrive Brake Control Solenoid Valve(UD/B_VFS). Description and Operation
Description
Underdrive brake control solenoid valve(UD/B_VFS) is attached to the valve
body. This variable force solenoid valve directly controls the hydraulic pressure
inside the underdrive ...
See also:
Immobilizer Control Unit. Repair
procedures
Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Remove the crash pad lower panel.
(Refer to the BD group - "Crash ...
Troubleshooting
Failure Diagnosis
1.
In principle, ESC and TCS controls are prohibited in case of ABS
failure.
2.
When ESC or TCS fails, only the failed s ...
Limp Home Function
1.
Limp Home By Tester
If the PCM (ECM) detects the fault of the SMARTRA or transponder,
the PCM (ECM) will allow limp home function of the immobilizer. Limp
h ...
Hyundai Accent Manuals
В© 2011-2026 Copyright www.hamanual.com