Hyundai Accent Manuals

Hyundai Accent: Removal - Inhibitor Switch. Repair procedures - Automatic Transaxle Control System - Automatic Transaxle SystemHyundai Accent: Removal

Hyundai Accent RB (2010-2018) Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / Inhibitor Switch. Repair procedures / Removal

1.
Make sure vehicle does not roll before setting room side shift lever and T/M side manual control lever to "N" position.
2.
Remove the battery and the battery tray.
(Refer to "Charging system" in EE group.)
3.
Remove the air cleaner assembly.
(Refer to "Intake manifold" in EM group.)
4.
Remove the shift cable mounting nut (B).
Tightening torque:
7.8 ~ 11.8 N.m (0.8 ~ 1.2 Kgf.m, 5.7 ~ 8.6 lb-ft)
5.
Disconnect the inhibitor switch connector (A).
6.
Remove the manual control lever (B) and the washer after removing a nut (A).

When installing, affix the manual control lever and the inhibitor switch with Ø5mm (0.1969in.). Then tighten the inhibitor assembly mounting bolts.
7.
Remove the inhibitor assembly (A) after removing the bolts (2ea).
Tightening torque:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

When installing, tighten the inhibitor assembly mounting bolt lightly, so that necessary adjustments can be made. Tighten to specifications.

Inhibitor Switch. Repair procedures
...

Installation
1. Installation is the reverse of removal. ...

See also:

Inspection
Driver Airbag (DAB) If any improper parts are found during the following inspection, replace the airbag module with a new one. ...

Removal
1. Turn ignition switch OFF. 2. Remove the crash pad lower panel. (Refer to the Body group - "Crash pad") ...

Components Location
Supplemental Restraint System Control Module (SRSCM) Driver Airbag (DAB) / Passenger Airbag (PAB) Side Airbag (SAB) Curtain Airbag (CA ...

Hyundai Accent Manuals

В© 2011-2026 Copyright www.hamanual.com