Hyundai Accent Manuals

Hyundai Accent: Installation - Side Impact Sensor (SIS). Repair procedures - SRSCM - Restraint (Depowered)Hyundai Accent: Installation

Side Impact Sensor
•
Do not turn the ignition switch ON and do not connect the battery cable while replacing the side impact sensor.
1.
Install the new side impact sensor with the bolt then connect the side impact sensor connector.

Tightening torque:
7.0 ~ 9.0 N.m (0.71 ~ 0.92 kgf.m, 5.2 ~ 6.6 lb-ft)

2.
Install the center pillar trim.
(Refer to the Body group - "Interior trim")
3.
Install the door scuff trim.
(Refer to the Body group - "Interior trim")
4.
Reconnect the battery negative cable.
5.
After installing the Side Impact Sensor, confirm proper system operation:
A.
Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.

Removal
Side Impact Sensor 1. Disconnect the battery negative cable and wait for at least three minutes before beginning work. 2. Remove the d ...

Schematic Diagrams
...

See also:

Parking Brake Assembly. Components and Components Location
Components 1. Parking brake lever 2. Adjuster cable 3. Equalizer assembly 4. Parking brake cable ...

Curtain air bag
Curtain air bags are located along both sides of the roof rails above the front and rear doors. They are designed to help protect the heads of the front seat occupants and the rear outboard sea ...

Removal
The side airbag cannot be disassembled from the seat back assembly, so replace assembly when replacing the side airbag. ...

Hyundai Accent Manuals

© 2011-2026 Copyright www.hamanual.com