Hyundai Accent: Repair proceduresInspection
| 1. |
After disconnecting the vapor hose from the PCV valve,
remove the PCV valve.
|
| 2. |
Reconnect the PCV valve to the vapor hose.
|
| 3. |
Run the engine at idle, then put a finger over the
open end of the PCV valve and make sure that intake manifold vacuum
can be felt.
|
| 4. |
If the vacuum is not felt inspect PCV operation,
if operating correctly clean or replace the vapor hose.
|
Schematic Diagrams
Positive Crankcase
Ventilation (PCV) Valve. Description and OperationTo resume cruising speed at more than approximately 25 mph (40 km/h)
If any method other than the cruise ON/OFF switch was used to cancel cruising
speed and the system is still activated, the most recent set speed will automatically
resume when the RES+ switch is ...
General Service Information
Protection Of The Vehicle
Always be sure to cover fenders, seats, and floor areas before
starting work.
The support rod m ...
Input Speed Sensor. Specifications
Specifications
▷ Type: Hall effect sensor
Operation condition [°C(°F)]
((-)40 ~ 150)) -40 ~ 302
Air gap(mm)in.
(1.2 ~ 1.8)
0.0472 ...