Hyundai Accent Manuals

Hyundai Accent: Replacement - Rear Disc Brake. Repair procedures - Brake System - Brake SystemHyundai Accent: Replacement

Hyundai Accent RB (2010-2018) Service Manual / Brake System / Brake System / Rear Disc Brake. Repair procedures / Replacement

Rear Brake Pads
1.
Loosen the guide rod bolt (B) and then remove the rear caliper body (A).
Tightening torque:
21.6 ~ 31.4 N.m (2.2 ~ 3.2 kgf.m, 15.9 ~23.1 lb-ft)

•
Where necessary prevent the guide rods from rotating with an appropriate wrench.
•
Be careful not to damage the dust covers.
2.
Replace pad retainers (A) and brake pads (B) in the caliper carrier (C).

•
Clean the pad retainer surface at the caliper bracket.
•
Inspect the piston boots for damage and replace if necessary.
•
Check the smooth action of the guide rods, and their dust covers for damage.

Removal
1. Remove the rear wheel & tire. Tightening torque: 88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft) ...

Inspection
Rear Brake Disc Thickness Check 1. Check the brake pads for wear and fade. 2. Check the brake disc for damage and cracks. ...

See also:

Wheel replacement
When replacing the metal wheels for any reason, make sure the new wheels are equivalent to the original factory units in diameter, rim width and offset. WARNING A wheel that is not the correct si ...

Removal
1. Loosen the windshield wiper arm nut (A) after removing a wiper cap (B). 2. Remove the windshield wiper arm and blade. ...

Consumer information
This consumer information has been prepared in accordance with regulations issued by the National Highway Traffic Safety Administration of the U.S. Department of Transportation. Your Hyundai deale ...

Hyundai Accent Manuals

© 2011-2026 Copyright www.hamanual.com