Hyundai Accent Manuals

Hyundai Accent: Replacement - Transaxle Control Module (TCM). Repair procedures - Automatic Transaxle Control System - Automatic Transaxle SystemHyundai Accent: Replacement

Hyundai Accent RB (2010-2018) Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / Transaxle Control Module (TCM). Repair procedures / Replacement

1.
Turn ignition switch OFF.
2.
Disconnect the negative (-) battery cable.
3.
Disconnect the TCM connector (A).
4.
Remove the TCM after removing the bolt and nut.
TCM installation bolt/nut:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)


Inspection
TCM Problem Inspection Procedure 1. TEST TCM GROUND CIRCUIT: Measure resistance between TCM and chassis ground using the backside of TCM harness connector as TCM side ...

Installation
1. Installation is reverse of removal. In the case of the vehicle equipped wi ...

See also:

Inspection
Check for continuity between the terminals while operating the wiper and washer switch. If it is not normal condition, replace wiper and wiper switch. Wiper Switch Washer Switch ...

Schematic Diagram
...

Installation
1. Remove the ignition key from the vehicle. 2. Disconnect the battery negative cable from battery and wait for at least three minutes befo ...

Hyundai Accent Manuals

В© 2011-2026 Copyright www.hamanual.com