1. |
Disconnect the battery negative cable and wait for at least three
minutes before beginning work.
|
2. |
Remove the glove box housing.
(Refer to the Body group - "Crash pad")
|
3. |
Disconnect the passenger airbag connector (A) and remove the PAB
mounting bolt (B).
|
4. |
Remove the crash pad.
(Refer to the Body group - "Crash pad")
|
5. |
Remove the mounting bolts from the crash pad. Then remove the
passenger airbag.
|
Side repeater light bulb replacement
Type A
1. Remove the light assembly from the vehicle by prying the lens and pulling
the assembly out.
2. Disconnect the bulb electrical connector.
3. Separate the socket and the lens parts by t ...
Good braking practices
WARNING
Whenever you leave or park your vehicle, always set the parking brake
as far as possible and fully engage the vehicle's transaxle into the P (Park)
position. If the parking brak ...
Rail Pressure Sensor (RPS). Troubleshooting
Signal Waveform
...