Hyundai Accent Manuals

Hyundai Accent: Installation - Passenger Airbag (PAB) Module. Repair procedures - Airbag Module - Restraint (Advanced)Hyundai Accent: Installation

Hyundai Accent RB (2010-2018) Service Manual / Restraint (Advanced) / Airbag Module / Passenger Airbag (PAB) Module. Repair procedures / Installation

1.
Remove the ignition key from the vehicle.
2.
Disconnect the battery negative cable from battery and wait for at least three minutes before beginning work.
3.
Place a passenger airbag on the crash pad and tighten the passenger airbag mounting bolts.
Tightening torque:
7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)

4.
Install the crash pad.
(Refer to the Body group - "Crash pad")
5.
Tighten the passenger airbag mounting bolts.
Tightening torque:
7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)
6.
Connect the passenger airbag harness connector to the SRS main harness connector.
7.
Reinstall the glove box housing.
(Refer to the Body group - "Crash pad")
8.
Reconnect the battery negative cable.
9.
After installing the passenger airbag (PAB), confirm proper system operation:
A.
Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.

Removal
1. Disconnect the battery negative cable and wait for at least three minutes before beginning work. 2. Remove the glove box housing. ...

Side Airbag (SAB) Module. Description and Operation
Description The Side Airbags (SAB) are installed inside the front seat and protects the driver and passenger from danger when side crash occurs. The SRSCM determines deployment of side airba ...

See also:

Fuel Pressure Control Valve. Specifications
Specification Item Specification Coil Resistance (Ω) 0.5 [20°C(68°F) ...

Transaxle Oil Temperature Sensor. Schematic Diagrams
Circuit Diagram ...

Removal
1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Disconnect the connector (A), and then remove the se ...

Hyundai Accent Manuals

© 2011-2026 Copyright www.hamanual.com