Hyundai Accent: Installation
| 1. |
Installation is the reverse of removal.
|
| 2. |
Tighten the HECU mounting bolts and nuts to the specified torque.
|
| 3. |
After installation, bleed the brake system.
(Refer to ABS bleeding)
|
Removal
1.
Turn ignition switch OFF.
2.
Pull up the lock of the HECU connector (A), and then disconnect
the connector.
...
Front Wheel Speed
Sensor. Components and Components Location
Components
1. Front wheel speed sensor connector
2. Front wheel speed sensor
...
See also:
Removal
1.
Remove the ignition key from the vehicle.
2.
Disconnect the battery negative cable and wait for at least three
minutes before beginning ...
Repair procedures
Fuel Pressure Test
1.
Release the residual pressure in fuel line (Refer
to “Release Residual Pressure in Fuel Line” in this group).
...
ECM Problem Inspection Procedure
1.
TEST ECM GROUND CIRCUIT: Measure resistance between
ECM and chassis ground using the backside of ECM harness connector as
ECM side check point. If the problem is fo ...
Hyundai Accent Manuals
© 2011-2025 Copyright www.hamanual.com