Hyundai Accent: Removal
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the cluster fascia panel (A) after disconnecting the trip
switch connector(B).
|
| 3. |
Remove the cluster fascia (A) from the crash pad after removing
4 screws.
|
| 4. |
Disconnect the cluster fascia connecters(A) and then remove the
cluster.
|
Inspection
Speedometer
1.
Adjust the pressure of the tires to the specified level.
2.
Drive the vehicle onto a speedometer tester. Use wheel chocks
...
Installation
1.
Connect the cluster connector.
2.
Install the cluster assembly.
3.
Connect the trip switch connector.
...
See also:
Components and Components
Location
Components
1. HECU module
2. Front wheel speed sensor
3. Rear wheel speed sensor
4. Yaw rate & Lateral G sensor
5. Steering angle sensor
6. ABS Warning l ...
Anchor Pretensioner (APT). Description and Operation
Description
Front anchor pretensioner operates as well as Belt Pretensioner at the
same time If it gets into its deploy condition after a collision. It is located
at near anchor on driver se ...
Rear Wheel Speed Sensor. Components and Components Location
Components
1. Rear wheel speed sensor connector
2. Rear wheel speed sensor
...
Hyundai Accent Manuals
В© 2011-2025 Copyright www.hamanual.com