Hyundai Accent Manuals

Hyundai Accent: Installation - ETC (Electronic Throttle Control) System. Repair procedures - Engine Control System - Engine Control/Fuel SystemHyundai Accent: Installation

Hyundai Accent RB (2010-2018) Service Manual / Engine Control/Fuel System / Engine Control System / ETC (Electronic Throttle Control) System. Repair procedures / Installation

•
Install the component with the specified torques.
•
Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.
1.
Installation is reverse of removal.
Electronic throttle body Installation bolt:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

Removal
1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Remove the resonator and the air intake hose (Refer ...

Adjustment
ETC module learning procedure When installing new ETC module or re-installing it, ETC module learning procedure must be performed. 1. Hold the ignition k ...

See also:

Installation
1. Connect the cluster connector. 2. Install the cluster assembly. 3. Connect the trip switch connector. ...

Installation
Side Impact Sensor • Do not turn the ignition switch ON and do not connect the battery c ...

Repair procedures
Inspection Manual Transaxle Oil Inspection 1. Park the vehicle on a level ground and stop the engine. 2. Retighten the oil f ...

Hyundai Accent Manuals

© 2011-2026 Copyright www.hamanual.com