Hyundai Accent: Adjustment
| ETC module learning procedure |
When installing new ETC module or re-installing it, ETC module
learning procedure must be performed.
| 1. |
Hold the ignition key or the start button at th IG
ON position during 5 seconds.
|
| 2. |
Turn ignition swich OFF and then start the engine.
|
DTC codes (P0638, P2110) might be displayed if ETC
module learning procedure does not performed after replacing ETC module.
|
Installation
•
Install the component with the specified
torques.
•
...
Manifold Absolute Pressure
Sensor (MAPS). Description and Operation
Description
Manifold Absolute Pressure Sensor (MAPS) is a speed-density
type sensor and is installed on the surge tank. It senses absolute pressure
of the surge tank and transfers the analog ...
See also:
Replacement
1.
Disconnect the back up lamp switch connector (A).
2.
Remove the back up lamp switch (A).
3.
...
2. TCM Terminal Function
Connector [CHG-AA]
Pin
Description
Pin
Description
1
-
54
-
2
-
...
Tire chains
Tire chains, if necessary, should be installed on the front wheels.
Be sure that the chains are installed in accordance with the manufacturer's instructions.
To minimize tire and chain wear, do ...
Hyundai Accent Manuals
© 2011-2026 Copyright www.hamanual.com