Hyundai Accent: Fuel Tank Pressure Sensor
(FTPS). Description and Operation
Hyundai Accent RB (2010-2018) Service Manual / Engine Control/Fuel System / Engine Control System / Fuel Tank Pressure Sensor
(FTPS). Description and Operation
Description
Fuel Tank Pressure Sensor (FTPS) is a component of the evaporative
emission control system and is installed on the fuel tank, the fuel pump, or
the canister. It checks the purge control solenoid valve operation and detects
a leakage of the system.
Accelerator Position Sensor
(APS). Repair procedures
Inspection
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Turn the ignition switch ON.
3.
Measure the ...
Fuel Tank Pressure Sensor
(FTPS). Specifications
Specification
Pressure [kPa (kgf/cm², in
H2O)
Output Voltage (V)
-6.67 (-0.068, -26.8)
0.5
0
2.5
...
See also:
Distributing the sealant
11. Immediately drive approximately 4~6miles (7~10km or, about 10min) to evenly
distribute the sealant in the tire.
Do not exceed a speed of 50 mph (80 km/h). If possible, do not fall below a speed ...
Adjustment
Operate the horn, and adjust the tone to a suitable level by turning the
adjusting screw.
After adjustment, apply a small amo ...
Inspection
Battery Diagnostic Flow
Vehicle parasitic current inspection
1.
Turn the all electric devices OFF, and then turn
the ignition switch OFF.
...
Hyundai Accent Manuals
В© 2011-2024 Copyright www.hamanual.com