Hyundai Accent: Installation

Hyundai Accent RB (2010-2018) Service Manual / Engine Control/Fuel System / Fuel Delivery System / Fuel Pump. Repair procedures / Installation

1.

Installation is reverse of removal.

Fuel pump plate cover installation bolt :

1.96 ~ 2.94 N.m (0.2 ~ 0.3 kgf.m, 1.44 ~ 2.17 lb-ft)

Be careful of fuel pump direction when installing.

Removal

1. Release the residual pressure in fuel line (Refer to “Release Residual Pressure in Fuel Line” in this group). 2. Remove the rear sea ...

Inspection

[Fuel pump] 1. Turn ignition switch OFF and disconnect the negative (-)battery cable. 2. Remove the fuel pump assembly. ...

See also:

Removal
Replacing an on/off solenoid valve (SS-A, SS-B) does not require additional hydraulic pressure adjustment; however, the hydraul ...

Replacement
Hood Assembly Replacement • When removing and installing the hood, an assistant is neces ...

Wheel nut tightening torque
Steel wheel & aluminum alloy wheel: 65~79 lb·ft (9~11 kg·m) If you have a tire gauge, remove the valve cap and check the air pressure. If the pressure is lower than recommended, drive slowly ...

Hyundai Accent Manuals

© 2011-2025 Copyright www.hamanual.com