Hyundai Accent Manuals

Hyundai Accent: Inspection - Fuel Pump. Repair procedures - Fuel Delivery System - Engine Control/Fuel SystemHyundai Accent: Inspection

Hyundai Accent RB (2010-2018) Service Manual / Engine Control/Fuel System / Fuel Delivery System / Fuel Pump. Repair procedures / Inspection

[Fuel pump]
1.
Turn ignition switch OFF and disconnect the negative (-)battery cable.
2.
Remove the fuel pump assembly.
3.
Check motor operation by fuel pump connector (A) connecting power(No.2) and ground(No.4)

Pin No.
 discription
1
 Fuel sender signal
2
 Fuel pump (+)
3
 Fuel sender ground
4
 Fuel pump (-)

[Fuel sender]
1.
Using an ohmmeter, measure the resistance between terminals 1 and 3 of sender connector (A) at each float level.

Pin No.
 discription
1
 Fuel sender signal
2
 Fuel pump (+)
3
 Fuel sender ground
4
 Fuel pump (-)

2.
Also check that the resistance changes smoothly when the float is moved from "E" to "F".
Position
 Resistance (Ω)
 Capacity (ℓ)
E
 197 ~ 203
 2.8
 1/2
 64.2 ~ 68.2
 22.3
F
 6 ~ 10
 41.8


Installation
1. Installation is reverse of removal. Fuel pump plate cover installation bolt : 1.96 ~ 2.94 N.m (0.2 ~ 0.3 kgf.m, 1.44 ~ 2 ...

Fuel Filter. Repair procedures
Replacement 1. Remove the fuel pump (Refer to “Fuel Pump” in this group). 2. Disconnect the electric pump wiring connector (A) an ...

See also:

Repair procedures
Component Replacement After Deployment Before doing any SRS repairs, use the GDS to check for DTCs. Refer to the Diagnostic Tr ...

Inspection
Connecting Rod And Crankshaft 1. Check the connecting rod end play. Using feeler gauge, measure the end play while moving the connecting rod back and f ...

Winter driving
More severe weather conditions of winter result in greater wear and other problems. To minimize winter driving problem, you should follow these suggestions. ...

Hyundai Accent Manuals

© 2011-2026 Copyright www.hamanual.com