Hyundai Accent Manuals

Hyundai Accent: Installation - Automatic Transaxle. Repair procedures - General Information - Automatic Transaxle SystemHyundai Accent: Installation

1.
Installation is the reverse of removal.
If the oil seal on the transaxle case side is damaged and fluid is leaking, replace the oil seal with a new unit. When installing the new oil seal, use the specialized tool (oil seal installer, 09452-26100).
After replacement or reinstallation procedure of the automatic transaxle assembly, perform procedures below.
•
Adding automatic transaxle fluid.
(Refer to "Hydraulic system (Fluid)" in this group)
•
After servicing or replacing the automatic transaxle TCM, clear the diagnostic trouble codes (DTC) using the GDS tool.
Diagnostic trouble codes (DTC) cannot be cleared by disconnecting the battery.
•
When replacing the automatic transaxle and TCM, reset the diagnostic trouble code by using GDS.
•
Delete statement, use the GDS as possible.
•
When replacing the automatic transaxle, reset the automatic transaxle's values by using the GDS, A/T menu, "Option Treatment" and "Resetting Auto T/A Values".
•
Perform TCM learning after replacing the transaxle to prevent slow transaxle response, jerky acceleration and jerky startup.
(Refer to "Automatic transaxle control system (Repair procedures)" in this group)

Removal
1. Remove the following items; A. Engine cover (A). B. Air cleaner assembly and air duct (B). ...

Hydraulic System
...

See also:

Tire sidewall labeling
This information identifies and describes the fundamental characteristics of the tire and also provides the tire identification number (TIN) for safety standard certification. The TIN can be use ...

Installation
• Be sure to check the low pressure fuel hose quick-connector (A) is completely connected to ...

Removal
1. Disconnect the negative (-) battery terminal. 2. Using a screwdriver or remover, remove the center fascia garnish (A). ...

Hyundai Accent Manuals

© 2011-2025 Copyright www.hamanual.com