Hyundai Accent Manuals

Hyundai Accent: Rear Wheel Alignment - Alignment. Repair procedures-Revised - Tires/Wheels - Suspension SystemHyundai Accent: Rear Wheel Alignment

When using a commercially available computerized wheel alignment equipment to inspect the rear wheel alignment, always position the vehicle on a level surface.
Prior to inspection, make sure that the rear suspension system is in normal operating condition and that the tires are inflated to the specified pressure.
Toe


B - A. 0: Toe in (+)
B - A < 0: Toe out (-)

Toe is pre-set at the factory, so it does not need to be adjusted. If the toe is not within the standard value, replace or repair the damaged parts and then inspect again.

Toe:
Total : 0.5° (+0.4°/ -0.5°)
Individual :0.25°(+0.2°/ -0.25°)

Camber
Camber is pre-set at the factory, so it does not need to be adjusted. If the camber is not within the standard value, replace or repair the damaged parts and then inspect again.

Camber : -1.5°±0.5°


Front Wheel Alignment
When using a commercially available computerized wheel alignment equipment to inspect the front wheel alignment, always positio ...

Wheel. Repair procedures
Hub Nut Tightening Sequence Tighten the hub nuts as follows. Tightening torque : 88.3 ~ 107.9N.m (9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft) ...

See also:

Reassembly
• Thoroughly clean all parts to be assembled. • ...

Filter inspection
The climate control air filter should be replaced according to the Maintenance Schedule. If the vehicle is operated in severely air-polluted cities or on dusty rough roads for a long period, it sh ...

Speed sensing door lock system
All doors will be automatically locked after the vehicle speed exceeds 9 mph (15 km/h). And all doors will be automatically unlocked when you turn the engine off or when you remove the ignition ke ...

Hyundai Accent Manuals

© 2011-2026 Copyright www.hamanual.com