Hyundai Accent: Repair procedures
Hyundai Accent RB (2010-2018) Service Manual / Restraint (Advanced) / General Information / Repair procedures
Component Replacement After Deployment
Before doing any SRS repairs, use the GDS to check for DTCs. Refer
to the Diagnostic Trouble Code list for repairing of the related DTCs.
|
If the front airbag(s) deployed after a collision, replace the following
items.
| - |
SRSCM
|
| - |
Deployed airbag(s)
|
| - |
Seat belt pretensioner(s)
|
| - |
Anchor pretensioner(s)
|
| - |
Front impact sensor
|
| - |
SRS wiring harnesses
|
| - |
Inspect the clock spring for heat damage.
If any damage found, replace the clock spring.
|
If the side/curtain airbag(s) deployed after a collision, replace the
following items.
| - |
SRSCM
|
| - |
Deployed airbag(s)
|
| - |
Side impact sensor(s) for the deployed side(s)
|
| - |
SRS wiring harnesses
|
| - |
Deployed seat belt pretensioner(s)
|
After the vehicle is completely repaired, confirm the SRS airbag system
is OK.
| - |
Turn the ignition switch ON; the SRS indicator should come on
for about six seconds and then go off.
|
Description and Operation
Warning Lamp Activation
Warning Lamp Behavior after Ignition
On
As soon as the operating voltage is applied to the SRSCM ignition input,
the SRSCM activates the warning lamp fo ...
See also:
Components Location
Supplemental Restraint System Control
Module (SRSCM)
Driver Airbag (DAB) / Passenger Airbag
(PAB)
Side Airbag (SAB)
Curtain Airbag (CA ...
Inspection
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Measure the output voltage of the MAPS at idle and
IG ON.
...
Installation
1.
Remove the ignition key from the vehicle.
2.
Disconnect the battery negative cable from battery and wait for
at least three minutes befo ...
Hyundai Accent Manuals
В© 2011-2025 Copyright www.hamanual.com