Hyundai Accent: Brake Booster Operating Test
Hyundai Accent RB (2010-2018) Service Manual / Brake System / Brake System / Brake Booster. Repair procedures / Brake Booster Operating Test
For simple checking of the brake booster operation, carry out the following
tests.
| 1. |
Run the engine for one or two minutes, and then stop it. If the
pedal depresses fully the first time but gradually becomes higher when
depressed succeeding times, the booster is operating properly, if the
pedal height remains unchanged, the booster is inoperative.
|
| 2. |
With the engine stopped, step on the brake pedal several times.
Then step on the brake pedal and start the engine. If the pedal
moves downward slightly, the booster is in good condition. If there
is no change, the booster is inoperative.
|
| 3. |
With the engine running, step on the brake pedal and then stop
the engine.
Hold the pedal depressed for 30 seconds. If the pedal height does
not change, the booster is in good condition, if the pedal rises, the
booster is inoperative.
If the above three tests are okay, the booster performance can
be determined as good.
Even if one of the above three tests is not okay, check the check
valve, vacuum hose and booster for malfunction.
|
Removal
1.
Turn ignition switch OFF.
2.
Remove the battery and battery tray.
(Refer to Engine Electrical group - "Battery")
...
See also:
Installation
•
Install the component with the specified
torques.
•
...
Rear Torsion Beam Axle. Repair
procedures
Replacement
[Disc Type]
1.
Remove the rear wheel & tire.
Tightening torque :
88.3 ~ 107.9N.m(9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft) ...
Troubleshooting
Basic Troubleshooting
Basic Troubleshooting Guide
Customer Problem Analysis Sheet
Basic Inspection Procedure
Measuring Condition of Electronic Parts' Resistance
The ...
Hyundai Accent Manuals
© 2011-2026 Copyright www.hamanual.com