Hyundai Accent Manuals

Hyundai Accent: Disassembly - Cylinder Head. Repair procedures - Cylinder Head Assembly - Engine Mechanical SystemHyundai Accent: Disassembly

Hyundai Accent RB (2010-2018) Service Manual / Engine Mechanical System / Cylinder Head Assembly / Cylinder Head. Repair procedures / Disassembly

Identify MLA(Mechanical lash adjuster), valves, valve springs as they are removed so that each item can be reinstalled in its original position.
1.
Remove the MLAs (A).
When removing MLAs, mark all the MLAs for their rearrangement.

2.
Remove the valves.
(1)
Using the SST (09222 - 3K000, 09222 - 3K100), compress the valve spring and remove the retainer lock.
(2)
Remove the spring retainer.
(3)
Remove the valve spring.
(4)
Remove the valve.
(5)
Remove the valve stem seal.
(6)
Using a magnetic pickup tool, remove the spring seat.
Do not reuse the valve stem seals.

Removal
Engine removal is not required for this procedure. • Use fender covers to avoid damaging painted ...

Inspection
Cylinder Head 1. Inspect for flatness. Using a precision straight edge and feeler gauge, measure the surface the contacting the cylinder block and the ...

See also:

Overhead Console Lamp. Schematic Diagrams
Circuit Diagram ...

Vehicle break-in process
No special break-in period is needed. By following a few simple precautions for the first 600 miles (1,000 km) you may add to the performance, economy and life of your vehicle. Do not race the ...

ECM Problem Inspection Procedure
1. TEST ECM GROUND CIRCUIT: Measure resistance between ECM and chassis ground using the backside of ECM harness connector as ECM side check point. If the problem is fo ...

Hyundai Accent Manuals

© 2011-2026 Copyright www.hamanual.com