Hyundai Accent: Hazard Lamp Switch. Repair procedures

Installation

1. Install the bulb. 2. Connect the connector and install the trunk trim. ...

Removal

1. Disconnect the negative (-) battery terminal. 2. Using a screwdriver or remover, remove the center fascia garnish (A). ...

See also:

Replacement
Tail Gate Trim Replacement • When prying with a flat-tip screwdriver, wrap it with prote ...

To resume cruising speed at more than approximately 25 mph (40 km/h)
If any method other than the cruise ON/OFF switch was used to cancel cruising speed and the system is still activated, the most recent set speed will automatically resume when the RES+ switch is ...

Repair procedures
General Inspection After or before servicing the EPS system, perform the troubleshooting and test procedure as follows. Compare the system condition with normal condition in the table below ...