Hyundai Accent: Installation

Hyundai Accent RB (2010-2018) Service Manual / Body Electrical System / Lighting System / Hazard Lamp Switch. Repair procedures / Installation

1.	Install the hazard lamp switch.

2.	Connect the connectors.

3.	Install the center fascia garnish.

4.	Connect the negative (-) battery terminal.

Removal

1. Disconnect the negative (-) battery terminal. 2. Using a screwdriver or remover, remove the center fascia garnish (A). ...

Inspection

1. Operate the switch and check for continuity between terminals. ...

See also:

Removal
1. Disconnect the negative (-) battery terminal. 2. Loosen 2 screws holding the overhead console (A). 3. ...

Certification label
The certification label is located on the driver's door sill at the center pillar. This label shows the maximum allowable weight of the fully loaded vehicle. This is called the GVWR (Gross Ve ...

Installation
• Install the component with the specified torques. • ...

Hyundai Accent Manuals

© 2011-2025 Copyright www.hamanual.com