Hyundai Accent Manuals

Hyundai Accent: Inspection - Rear Wheel Speed Sensor. Repair procedures - ESC(Electronic Stability Control) System - Brake SystemHyundai Accent: Inspection

Hyundai Accent RB (2010-2018) Service Manual / Brake System / ESC(Electronic Stability Control) System / Rear Wheel Speed Sensor. Repair procedures / Inspection

1.
Measure the output voltage between the terminal of the wheel speed sensor and the body ground.
•
In order to protect the wheel speed sensor, when measuring output voltage, a 120 Ω resister must be used as shown.

2.
Compare the change of the output voltage of the wheel speed sensor to the normal change of the output voltage as shown below.

V_low: 0.7 V ~ 1.0 V
V_high: 1.4 V ~ 2.0 V
Frequency range: 1 ~ 2,500Hz

Removal
1. Remove the rear wheel and tire. Tightening torque: 88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft) ...

Yaw-rate and G Sensor. Description and Operation
Description When the vehicle is turning with respect to a vertical axis the yaw rate sensor detects the yaw rate electroniclly by the vibration change of plate fork inside the yaw rate senso ...

See also:

Inspection
Sprockets, Hydraulic Tensioner, Chain Guide, Tensioner Arm 1. Check the CVVT sprocket, crankshaft sprocket teeth for abnormal wear, cracks or damage. Repla ...

Replacement
1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. 2. Remove the front wheel and tire (A) fro ...

Removal
1. Disconnect the battery negative cable and wait for at least 3 minutes before beginning work. 2. Remove the roof trim. (Refer to ...

Hyundai Accent Manuals

© 2011-2026 Copyright www.hamanual.com