Hyundai Accent: Removal

Hyundai Accent RB (2010-2018) Service Manual / Brake System / ESC(Electronic Stability Control) System / Rear Wheel Speed Sensor. Repair procedures / Removal

1.

Remove the rear wheel and tire.

Tightening torque:

88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft)

2.

Remove the rear wheel speed sensor mounting bolt (A).

Tightening torque:

7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.7 ~ 8.8 lb-ft)

3.	Remove the rear seat back. (Refer to the Body group - Seat)

4.	Remove the rear wheel housing trim. (Refer to the Body group – interior trim)

5.	Disconnect the rear wheel speed sensor connector.

6.	Installation is the reverse of removal.

Rear Wheel Speed Sensor. Repair procedures

...

Inspection

1. Measure the output voltage between the terminal of the wheel speed sensor and the body ground. ...

See also:

Pre-tensioner seat belt
Your vehicle is equipped with driver's and front passenger's pre-tensioner seat belts. The purpose of the pre-tensioner is to make sure that the seat belts fit tightly against the occupa ...

SS-B Solenoid Valve(ON/OFF). Specifications
Specifications ON/OFF Solenoid Valve(SS-A, SS-B) ▷ Control type : Normal low type Control pressure kpa (kgf/cm², psi) 490.33(5.0, 71.12) ...

Inspection
1. Troubleshooting for Speaker (1) Basic inspection of speaker Inspect the sound from speaker after verifying that the s ...

Hyundai Accent Manuals

© 2011-2026 Copyright www.hamanual.com