Hyundai Accent: Inspection

Hyundai Accent RB (2010-2018) Service Manual / Body Electrical System / Ignition Switch Assembly / Repair procedures / Inspection

1.	Disconnect the ignition switch connector (B) and key switch connector (A) from under the steering column.

2.	Check for continuity between the terminals.

3.	If continuity is not specified, replace the switch.

Repair procedures

...

Removal

1. Disconnect the negative (-) battery terminal. 2. Remove the steering column upper and lower shrouds. (Refer to the ST group - & ...

See also:

Replacement
Rear Brake Pads 1. Loosen the guide rod bolt (B) and then remove the rear caliper body (A). Tightening torque: 21.6 ~ 31 ...

Input Speed Sensor. Specifications
Specifications ▷ Type: Hall effect sensor Operation condition [°C(°F)] ((-)40 ~ 150)) -40 ~ 302 Air gap(mm)in. (1.2 ~ 1.8) 0.0472 ...

Removal
1. Disconnect the negative (-) battery terminal. 2. Remove the cluster fascia panel (A) after disconnecting the trip switch connector(B). ...

Hyundai Accent Manuals

© 2011-2026 Copyright www.hamanual.com