Hyundai Accent: Repair procedures

Ignition Switch Assembly

...

Inspection

1. Disconnect the ignition switch connector (B) and key switch connector (A) from under the steering column. 2. Check for continui ...

See also:

Transmitter Code Registration (Using GDS)
1. Connect the DLC cable of GDS to the data link connector (16 pins) in driver side crash pad lower panel, turn the power on GDS. 2. ...

Removal
1. Disconnect the negative (-) battery terminal. 2. Remove the trunk trim. (Refer to the BD group - " Trunk Lid") ...

ETC (Electronic Throttle Control) System. Troubleshooting
Fail-Safe Mode Item Fail-Safe ETC Motor Throttle valve stuck at 7° TPS TPS 1 fault ECM looks at TPS2 ...