1. |
Disconnect the back up lamp switch connector (A).
|
2. |
Check the continuity between no. 1 and 2 terminals of backup lamp
switch. When the shift lever is in reverse, there should be continuity.
|
3. |
If necessary, repair or replace the backup lamp switch.
|
Wheel nut tightening torque
Steel wheel & aluminum alloy wheel:
65~79 lb·ft (9~11 kg·m)
If you have a tire gauge, remove the valve cap and check the air pressure. If
the pressure is lower than recommended, drive slowly ...
Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the oil temperature sensor connector.
3.
Measure resistance between ...
Console. Repair procedures
Replacement
Floor Console Replacement
[ M/T ]
•
When prying with a flat-tip screw ...