Hyundai Accent: Replacement

Hyundai Accent RB (2010-2018) Service Manual / Manual Transaxle System (M6CF1) / Manual Transaxle Control System / Back-up Lamp Switch. Repair procedures / Replacement

1.	Disconnect the back up lamp switch connector (A).

2.	Remove the back up lamp switch (A).

3.

Replace a new one and install the back up lamp switch.

Tightening torque:

29.4 ~ 34.3 N.m (3.0 ~ 3.5 kgf.m, 21.7 ~ 25.3 lb-ft)

Inspection

1. Disconnect the back up lamp switch connector (A). 2. Check the continuity between no. 1 and 2 terminals of backup lamp switch. W ...

Automatic Transaxle System

...

See also:

Fuel Pressure Control Valve. Schematic Diagrams
Circuit Diagram (M/T) (A/T) ...

Certification label
The certification label is located on the driver's door sill at the center pillar. This label shows the maximum allowable weight of the fully loaded vehicle. This is called the GVWR (Gross Ve ...

Installation
1. Remove the ignition key from the vehicle. 2. Disconnect the battery negative cable from battery and wait for at least three minutes befo ...

Hyundai Accent Manuals

© 2011-2026 Copyright www.hamanual.com