Hyundai Accent: Inspection
| 1. |
Turn ignition switch OFF.
|
| 2. |
Disconnect the oil temperature sensor connector.
|
| 3. |
Measure resistance between sensor signal terminal and sensor ground
terminal.
|
| 4. |
Check that the resistance is within the specification.
|
Removal
Replacing an on/off solenoid valve (SS-A, SS-B) does not require
additional hydraulic pressure adjustment; however, the hydraul ...
See also:
Battery replacement
The transmitter uses a 3 volt lithium battery which will normally last for several
years. When replacement is necessary, use the following procedure.
1. Insert a slim tool into the slot and gentl ...
Components and Components Location
Components Location
1. Sub frame
2. Drive shaft
3. Lower arm
4. Strut assembly
5. Steering gearbox
6. Stabilizer bar
...
Removal and Installation
1.
Disconnect the battery terminals. (Refer to Engine
and transaxle assembly in this group)
2.
Remove the air cleaner assembly. (Refer to E ...
Hyundai Accent Manuals
В© 2011-2026 Copyright www.hamanual.com