Hyundai Accent: Installation

Inspection

1. Check the bushing for wear. 2. Check the brake pedal for bending or twisting. 3. Check the brake pedal retur ...

Adjustment

Brake Pedal Height and Free Play 1. Disconnect the stop lamp switch connector (A). 2. Adjust the brake pedal height (A) as illustra ...

See also:

ESC OFF Switch. Repair procedures
Inspection 1. Turn ignition switch OFF and disconnect the negative (-) battery cable. 2. Remove the crash pad lower panel. (Refer ...

Inspection
Throttle Position Sensor (TPS) 1. Connect the GDS on the Data Link Connector (DLC). 2. Start the engine and measure the output voltage of ...

Hazard warning flasher
The hazard warning flasher should be used whenever you find it necessary to stop the car in a hazardous location. When you must make such an emergency stop, always pull off the road as far as po ...