Hyundai Accent Manuals

Hyundai Accent: Inspection - Front Disc Brake. Repair procedures - Brake System - Brake SystemHyundai Accent: Inspection

Hyundai Accent RB (2010-2018) Service Manual / Brake System / Brake System / Front Disc Brake. Repair procedures / Inspection

Front Brake Disc Thickness Check
1.
Check the brake pads for wear and fade.
2.
Check the brake disc for damage and cracks.
3.
Remove all rust and contamination from the surface, and measure the disc thickness at 8 points, at least, of same distance (5mm) from the brake disc outer circle.
Brake disc thickness
Standard: 22 mm (0.866 in)
Service limit: 20 mm (0.787 in)
Deviation: Less than 0.005 mm (0.0002 in)

4.
If wear exceeds the limit, replace the discs and pad assembly left and right of the vehicle.
Front Brake Pad Check
1.
Check the pad wear. Measure the pad thickness and replace it, if it is less than the specified value.
Pad thickness
Standard value: 11 mm (0.433 in)
Service limit: 2.0 mm (0.0787 in)
2.
Check the damage of pad, backing metal and contamination with grease.
Front Brake Disc Runout Check
1.
Place a dial gauge about 5mm (0.2 in.) from the outer circumference of the brake disc, and measure the runout of the disc.
Brake disc runout
Limit: 0.04 mm (0.0016 in.) or less (new one)

2.
If the runout of the brake disc exceeds the limit specification, replace the disc, and then measure the runout again.
3.
If the runout does not exceed the limit specification, install the brake disc after turning it 180° and then check the runout of the brake disc again.
4.
If the runout cannot be corrected by changing the position of the brake disc, replace the brake disc.

Replacement
Front Brake Pads 1. Remove the brake hose mounting bracket bolt (A). Tightening torque: 7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.7 ...

Installation
1. Installation is the reverse of removal. 2. Use a SST (09581-11000) when installing the brake caliper assembly. 3 ...

See also:

SS-B Solenoid Valve(ON/OFF). Specifications
Specifications ON/OFF Solenoid Valve(SS-A, SS-B) ▷ Control type : Normal low type Control pressure kpa (kgf/cm², psi) 490.33(5.0, 71.12) ...

General Service Information
Protection Of The Vehicle Always be sure to cover fenders, seats, and floor areas before starting work. The support rod m ...

Rear Wheel Alignment
When using a commercially available computerized wheel alignment equipment to inspect the rear wheel alignment, always position ...

Hyundai Accent Manuals

© 2011-2026 Copyright www.hamanual.com