Hyundai Accent: Removal

Inspection

Horn Inspection Test the horn by connecting battery voltage to the 2 terminal and ground the 1 terminal. 1 : 12V Ground(-) 2 : 12V (+) ...

Installation

1. Connect the horn connector, then reassemble the horn. ...

See also:

Repair procedures
General Inspection After or before servicing the EPS system, perform the troubleshooting and test procedure as follows. Compare the system condition with normal condition in the table below ...

Installation
1. Remove the ignition key from the vehicle. 2. Disconnect the battery negative cable and wait for at least three minutes. ...

Removal
1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Disconnect the variable intake solenoid valve connector ...