Hyundai Accent: Installation

Hyundai Accent RB (2010-2018) Service Manual / Body Electrical System / Lighting System / Overhead Console Lamp. Repair procedures / Installation

1.	Install the overhead console lamp after connecting the sunroof switch connector and lamp connector.

2.	Install the lens after tightening 2 screws.

Removal

1. Disconnect the negative (-) battery terminal. 2. Loosen 2 screws holding the overhead console (A). 3. ...

License Lamp. Repair procedures

...

See also:

Removal
1. Remove the rear wheel & tire. Tightening torque: 88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft) ...

Side Impact Sensor (SIS). Description and Operation
Description The Side Impact Sensor (SIS) system consists of two front SIS which are installed inside the Center Pillar (LH and RH). They are remote sensors that detect acceleration due to co ...

Inspection
1. Check the signal waveform of the CMPS and CKPS using the GDS. Specification: Refer to “Wave Form” ...

Hyundai Accent Manuals

© 2011-2026 Copyright www.hamanual.com