Hyundai Accent: Removal
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Loosen 2 screws holding the overhead console (A).
|
| 3. |
Disconnect the connectors (A) of sunroof switch and lamp switch
then remove the overhead console lamp assembly.
|
| 4. |
If necessary to replace the bulb, replace the bulb after opening
the overhead console lens.
|
Inspection
Remove the overhead console lamp assembly then check for continuity between
terminals. If the continuity is not as specified, replace the map lamp switch.
...
Installation
1.
Install the overhead console lamp after connecting the sunroof
switch connector and lamp connector.
2.
Install the lens after tightening ...
See also:
Removal
1.
Release the residual pressure in fuel line (Refer
to “Release Residual Pressure in Fuel Line” in this group).
2.
Remove the rear sea ...
Seat Belt Pretensioner (BPT). Description and Operation
Description
The Seat Belt Pretensioners (BPT) are installed inside Center Pillar (LH
& RH). When a vehicle crashes with a certain degree of frontal impact, the pretensioner
seat belt hel ...
Installation
1.
Install the wiper motor.
2.
Install the crank arm.
3.
Install the lower and upper linkage to the wiper motor ...
Hyundai Accent Manuals
© 2011-2026 Copyright www.hamanual.com