Hyundai Accent Manuals

Hyundai Accent: Installation - Purge Control Solenoid 
Valve (PCSV). Repair procedures - Engine Control System - Engine Control/Fuel SystemHyundai Accent: Installation

•
Install the component with the specified torques.
•
Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.
•
Use care to keep foreign material out of the valve.
1.
Installation is reverse of removal.

Purge control solenoid valve bracket installation bolt: 9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)


Removal
1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Disconnect the purge control solenoid valve connector ...

CVVT Oil Control Valve (OCV). Description and Operation
Description Continuous Variable Valve Timing (CVVT) system advances or retards the valve timing of the intake and exhaust valve in accordance with the ECM control signal which is calculated ...

See also:

If engine doesn't turn over or turns over slowly
1. If your vehicle has an automatic transaxle, be sure the shift lever is in N (Neutral) or P (Park) and the emergency brake is set. 2. Check the battery connections to be sure they are clean and t ...

Removal
Rear Disc Brake Type The parking brake cables must not be bent or distorted. This will lead to stiff operation and ...

Lift And Support Points
When heavy rear components such as suspension, fuel tank, spare tire, tailgate and trunk lid are to be removed, place additiona ...

Hyundai Accent Manuals

© 2011-2026 Copyright www.hamanual.com