Hyundai Accent: Installation

Hyundai Accent RB (2010-2018) Service Manual / Engine Control/Fuel System / Fuel Delivery System / Fuel Pump. Repair procedures / Installation

1.

Installation is reverse of removal.

Fuel pump plate cover installation bolt :

1.96 ~ 2.94 N.m (0.2 ~ 0.3 kgf.m, 1.44 ~ 2.17 lb-ft)

Be careful of fuel pump direction when installing.

Removal

1. Release the residual pressure in fuel line (Refer to “Release Residual Pressure in Fuel Line” in this group). 2. Remove the rear sea ...

Inspection

[Fuel pump] 1. Turn ignition switch OFF and disconnect the negative (-)battery cable. 2. Remove the fuel pump assembly. ...

See also:

Vehicle certification label
The vehicle certification label attached on the driver’s side center pillar contains the vehicle identification number (VIN). ...

Installation
1. Install the heater & air conditioning controller. 2. Install the audio unit. 3. Connect the battery (-) ...

Inspection
1. Disconnect the back up lamp switch connector (A). 2. Check the continuity between no. 1 and 2 terminals of backup lamp switch. W ...

Hyundai Accent Manuals

© 2011-2026 Copyright www.hamanual.com