Hyundai Accent Manuals

Hyundai Accent: Installation - Torque Converter Control Solenoid Valve (T/CON_VFS). Repair procedures - Automatic Transaxle Control System - Automatic Transaxle SystemHyundai Accent: Installation

Hyundai Accent RB (2010-2018) Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / Torque Converter Control Solenoid Valve (T/CON_VFS). Repair procedures / Installation

1.
Installation is the reverse of removal.
•
The gasket of the valve body cover gasket (A) use new one.
•
Adding automatic transaxle fluid.
(Refer to "Hydraulic system (Fluid)" in this group)

•
Perform TCM learning after replacing the automatic transaxle to prevent slow automatic transaxle response, jerky acceleration and jerky startup.
(Refer to "Automatic transaxle control system (Repair procedures)" in this group)

Removal
1. Remove the battery and the battery tray. (Refer to "Charging system" in EE group.) 2. Remove the under cover (A). ...

26 Brake Control Solenoid Valve(26/B_VFS). Description and Operation
Description 26 brake control solenoid valve(26/B_VFS) is attached to the valve body. This variable force solenoid valve directly controls the hydraulic pressure inside the 26 brake. ...

See also:

Installation
When replacing the ECM, the vehicle equipped with the immobilizer must be performed procedure as below. [In the ...

Front Impact Sensor (FIS). Description and Operation
Description The front impact sensor (FIS) is installed in the front side member. They are remote sensors that detect acceleration due to a collision at its mounting location. The primary pur ...

Windshield wipers
Operates as follows when the ignition switch is turned ON. MIST : For a single wiping cycle, push the lever upward and release it with the lever in the OFF position. The wipers will operate continu ...

Hyundai Accent Manuals

© 2011-2026 Copyright www.hamanual.com