Hyundai Accent Manuals

Hyundai Accent: Installation - Front Impact Sensor (FIS). Repair procedures - SRSCM - Restraint (Advanced)Hyundai Accent: Installation

Hyundai Accent RB (2010-2018) Service Manual / Restraint (Advanced) / SRSCM / Front Impact Sensor (FIS). Repair procedures / Installation

•
Do not turn the ignition switch ON and do not contact the battery cable while replacing the front impact sensor.
1.
Install the new front impact sensor.
2.
Tighten the front impact sensor mounting bolt.
Tightening torque:
7.0 ~ 9.0 N.m (0.71 ~ 0.92 kgf.m, 5.2 ~ 6.6 lb-ft)
3.
Connect the front impact sensor connector.
4.
Install the washer reservoir.
(Refer to the Body Electrical group - "Washer motor")
[Right side only]
5.
Install the front bumper.
(Refer to the Body group - "Front bumper")
6.
Reconnect the battery negative cable.
7.
After installing the Front Impact Sensor, confirm proper system operation:
A.
Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.

Removal
• Removal of the airbag must be performed according to the precautions/ procedures described ...

Side Impact Sensor (SIS). Description and Operation
Description Side Impact Sensor (SIS) system consists of two P-SIS which are installed at each center of the front door module (LH and RH) and two SIS which are installed at each center pilla ...

See also:

Vehicle certification label
The vehicle certification label attached on the driver’s side center pillar contains the vehicle identification number (VIN). ...

ECM Problem Inspection Procedure
1. TEST ECM GROUND CIRCUIT: Measure resistance between ECM and chassis ground using the backside of ECM harness connector as ECM side check point. If the problem is fo ...

Installation
1. Install the heater & air conditioning controller. 2. Install the audio unit. 3. Connect the battery (-) ...

Hyundai Accent Manuals

© 2011-2026 Copyright www.hamanual.com